| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_ffa: Validate framework notification message layout
Framework notifications carry an indirect message in the shared RX
buffer. Validate the reported offset and size before using them, reject
zero-length payloads, and ensure that any non-header payload starts at
the UUID field rather than in the middle of the message header.
Use the validated offset and size values for both kmemdup() and the UUID
parsing path so malformed firmware data cannot drive an out-of-bounds
read or an oversized allocation. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/adm1266) cap PDIO scan in get_multiple at ADM1266_PDIO_NR
adm1266_gpio_get_multiple() iterates the PDIO portion of the
caller-supplied mask using
for_each_set_bit_from(gpio_nr, mask,
ADM1266_GPIO_NR + ADM1266_PDIO_STATUS) {
...
}
where ADM1266_PDIO_STATUS is the PMBus command code (0xE9, i.e. 233),
not the number of PDIO pins. The intended upper bound is
ADM1266_GPIO_NR + ADM1266_PDIO_NR = 25.
gpiolib hands in a mask sized for gc.ngpio (= 25 bits on this chip),
so the iteration walks find_next_bit() up to 242, reading up to 217
extra bits (a handful of unsigned-long words: four on 64-bit, seven
on 32-bit) of whatever lives past the end of the mask in the
caller's stack. Any incidental set bit in that range then drives a
set_bit(gpio_nr, bits) call that writes past the end of the
caller-supplied bits array too -- both out-of-bounds.
Substitute ADM1266_PDIO_NR for the constant so the scan stops at the
last real PDIO bit. |
| In the Linux kernel, the following vulnerability has been resolved:
block: don't overwrite bip_vcnt in bio_integrity_copy_user()
bio_integrity_add_page() already sets bip_vcnt to 1 for the bounce
segment. Overwriting it with nr_vecs breaks bip_vcnt <= bip_max_vcnt
on WRITE (bip_max_vcnt is 1), so the gap-merge checks in block/blk.h
read past the bip_vec[] flex array. On READ the read is in bounds
but lands on a saved user bvec instead of the bounce.
The line was added for split propagation, but bio_integrity_clone()
doesn't copy bip_vcnt and BIP_CLONE_FLAGS excludes BIP_COPY_USER. |
| mod_auth_openidc is an OpenID Certified authentication and authorization module for the Apache 2.x HTTP server that implements the OpenID Connect Relying Party functionality. Prior to 2.4.19.4, an out-of-bounds read and a one-byte out-of-bounds write exist in the state-cookie parser of `mod_auth_openidc`. The issue is fixed in version 2.4.19.4 by stopping the scan at the string terminator so a value-less token is rejected. No in-product workarounds are available. As a stop-gap, an upstream reverse proxy or WAF that rejects or normalizes malformed `Cookie` headers (tokens lacking `=`) can reduce exposure, but upgrading is the recommended remediation. |
| A maliciously crafted DWG or DXF file, when parsed through Autodesk AutoCAD, can force an Out-of-Bounds Read vulnerability. A malicious actor can leverage this vulnerability to cause a crash or disclose sensitive information. |
| A maliciously crafted DWG or DXF file, when parsed through Autodesk AutoCAD, can force an Out-of-Bounds Read vulnerability. A malicious actor can leverage this vulnerability to cause a crash or disclose sensitive information. |
| A flaw was found in the file-xwd plugin in GIMP. When processing a specially crafted XWD image file, the plugin validates the image width and bytes-per-line parameters independently rather than ensuring their combined values are consistent with the allocated buffer size. This incorrect validation leads to improper bounds checking, causing a heap out-of-bounds read. This issue can result in an application crash, leading to a denial of service or a limited information disclosure of heap memory contents into the produced image. |
| In the Linux kernel, the following vulnerability has been resolved:
ibmvnic: Use kernel helpers for hex dumps
Previously, when the driver was printing hex dumps, the buffer was cast
to an 8 byte long and printed using string formatters. If the buffer
size was not a multiple of 8 then a read buffer overflow was possible.
Therefore, create a new ibmvnic function that loops over a buffer and
calls hex_dump_to_buffer instead.
This patch address KASAN reports like the one below:
ibmvnic 30000003 env3: Login Buffer:
ibmvnic 30000003 env3: 01000000af000000
<...>
ibmvnic 30000003 env3: 2e6d62692e736261
ibmvnic 30000003 env3: 65050003006d6f63
==================================================================
BUG: KASAN: slab-out-of-bounds in ibmvnic_login+0xacc/0xffc [ibmvnic]
Read of size 8 at addr c0000001331a9aa8 by task ip/17681
<...>
Allocated by task 17681:
<...>
ibmvnic_login+0x2f0/0xffc [ibmvnic]
ibmvnic_open+0x148/0x308 [ibmvnic]
__dev_open+0x1ac/0x304
<...>
The buggy address is located 168 bytes inside of
allocated 175-byte region [c0000001331a9a00, c0000001331a9aaf)
<...>
=================================================================
ibmvnic 30000003 env3: 000000000033766e |
| In the Linux kernel, the following vulnerability has been resolved:
mm/util: don't read __page_2 for order-1 folios in snapshot_page()
snapshot_page() currently reads __page_2 after checking nr_pages > 1, but
it should only do so when nr_pages > 2.
If an order-1 folio is allocated at the end of a vmemmap section,
__page_2 will not exist and reading it will cause a fault.
During DLPAR memory remove on a 22 TB ppc64le LPAR, snapshot_page() oopsed
on the page isolation path while reading an order-1 folio's __page_2 from
an adjacent absent section (unmapped vmemmap).
Fix this to avoid reading memmap that doesn't exist (e.g., a vmemmap
hole). |
| This CVE ID has been rejected as a duplicate. |
| A flaw was found in the MTP backend in gvfs. When reading a file from a mounted MTP device, do_read() in gvfsbackendmtp.c trusts the data length returned by the device without limiting it to the original size requested by the client. If a malicious MTP device responds with more bytes than requested, this unrestricted length is passed directly to memcpy(). This causes the operation to read memory outside the intended boundaries. This allows an attacker who plugs in a malicious MTP device to cause a segmentation fault when a file is read and crash the gvfsd-mtp process, resulting in a denial of service. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: flowtable: avoid num_encaps underflow on bridge VLAN untag
The DEV_PATH_BR_VLAN_UNTAG case post-decrements info->num_encaps
inside WARN_ON_ONCE(). num_encaps is u8, so if it's already 0 the
decrement still happens and wraps it to 255. The break only leaves
the inner switch -- a later path entry can set info->indev back to
a real device, and we end up returning with num_encaps == 255.
nft_dev_forward_path() then walks info.encap[] (size 2) up to
num_encaps, which means an OOB stack read and a bogus count copied
into the route descriptor.
Should only happen on a malformed bridge path stack, hence the WARN,
but worth handling sanely. Move the decrement out of the WARN.
[ While at this, remove the WARN_ON_ONCE since this can only happen
with a buggy bridge path stack --pablo ]. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: wcn36xx: fix OOB read from short trigger BA firmware response
The firmware response length is only checked against sizeof(*rsp) (20
bytes), but when candidate_cnt >= 1, a 22-byte candidate struct is read
at buf + 20 without verifying the response contains it. This causes an
out-of-bounds read of stale heap data, corrupting the BA session state.
Add validation that the response includes the candidate data. |
| A type confusion vulnerability in the iked process of WatchGuard Fireware OS allows a remote unauthenticated attacker to execute arbitrary code by sending specially crafted network traffic. |
| Out-of-bounds read for some Intel(R) PROSet/Wireless WiFi Software within Ring 2: Device Drivers may allow an escalation of privilege. Network adversary with an unauthenticated user combined with a low complexity attack may enable escalation of privilege. This result may potentially occur via adjacent access when attack requirements are not present without special internal knowledge and requires no user interaction. The potential vulnerability may impact the confidentiality (low), integrity (low) and availability (high) of the vulnerable system, resulting in subsequent system confidentiality (low), integrity (low) and availability (low) impacts. |
| An attacker that has valid credentials can open many connections to the imap-hibernate service and send invalid commands, which can intermittently cause an out-of-bounds read and crash the process. The crash interrupts hibernated IMAP sessions handled by the affected process, which can cause degradation of service for IMAP. Disable IMAP hibernation. Update to non-vulnerable version. No publicly available exploits are known. |
| A flaw was found in the file-pix (ESM) plugin in GIMP. When processing a specially crafted PIX image file, the plugin allocates a Variable-Length Array (VLA) on the stack without proper bounds checking, causing an unbounded stack allocation followed by a 21-byte stack over-read. This can result in a denial of service due to stack exhaustion and a limited information disclosure of stack memory contents into an intermediate file. |
| Out-of-bounds read for some Intel(R) PROSet/Wireless WiFi Software for Windows within Ring 0: Kernel may allow a denial of service. Unprivileged software adversary with an unauthenticated user combined with a high complexity attack may enable denial of service. This result may potentially occur via adjacent access when attack requirements are present without special internal knowledge and requires no user interaction. The potential vulnerability may impact the confidentiality (none), integrity (none) and availability (high) of the vulnerable system, resulting in subsequent system confidentiality (none), integrity (none) and availability (high) impacts. |
| The LoRaWAN application-layer clock-synchronization service parses downlinks in clock_sync_package_callback() (subsys/lorawan/services/clock_sync.c). Its command loop only guarantees that the one-byte command id is in bounds; for the CLOCK_SYNC_CMD_APP_TIME (AppTimeAns) command the handler then reads a 4-byte time correction via sys_get_le32() plus a 1-byte token without checking that 5 bytes remain in the receive buffer (len - rx_pos). A short or crafted AppTimeAns therefore reads up to 5 bytes past the end of the decrypted payload.
The payload (rx_buf/len) is the decrypted application frame delivered to the registered downlink callback (mcps_indication->Buffer/BufferSize). Reaching the handler requires a frame on the clock-sync port that passes LoRaWAN's MAC integrity check and FRMPayload decryption, so the practical attacker is a malicious or compromised network/application server (the designated sender of AppTimeAns) or a party holding the session keys, rather than an arbitrary radio listener.
The over-read is bounded: the backing store is a fixed 255-byte static buffer, so the few stray bytes do not fault, and the read values (time_correction, token) are used only internally and never transmitted, so there is no disclosure to the attacker and no crash. The sole effect is that a stale token matching ctx.req_token can apply a garbage time_correction to the device's own clock offset (ctx.time_offset), a minor integrity impact confined to the victim's time estimate. The fix adds an explicit length check that drops a too-short AppTimeAns. Note the sibling one-byte reads in the periodicity and force-resync handlers remain unguarded with the same negligible impact. |
| The LoRaWAN TS004 Fragmented Data Block Transport handler frag_transport_package_callback() in subsys/lorawan/services/frag_transport.c parses downlink command bytes without validating that enough payload bytes remain before each access. The loop's only bound is rx_pos < len; after consuming the one-byte command id the handler cast rx_buf + rx_pos to a 10-byte struct frag_transport_setup_req, and for a DATA_FRAGMENT command passed &rx_buf[rx_pos] to the fragment decoder, which reads exactly ctx.frag_size bytes — with no remaining-length check in either case.
The fragment size is attacker-chosen in a preceding FRAG_SESSION_SETUP command (ctx.frag_size = req->frag_size, capped at CONFIG_LORAWAN_FRAG_TRANSPORT_MAX_FRAG_SIZE, default 232). rx_buf aliases the 255-byte static MacCtx.RxPayload buffer in the loramac-node MAC layer, while len is the actual decrypted payload length. By padding a downlink with mismatched-index DATA_FRAGMENT filler commands (each advancing rx_pos by three bytes without producing an answer) and appending one matching-index fragment near the end of the payload, an attacker can make the decoder read up to roughly frag_size bytes past the end of RxPayload, copying adjacent static memory into the decoder buffers and the FUOTA flash image.
The handler runs only on downlinks that have already passed the LoRaWAN frame MIC and FRMPayload decryption, so the defect is reachable only by a party holding the device's session keys (the FUOTA server or an attacker who has compromised those keys). The out-of-bounds bytes are never returned to the sender — the only uplink emitted is a status answer carrying fragment counts — so there is no direct disclosure channel, and on typical flat-memory LoRaWAN MCUs the over-read stays within mapped memory, making a crash unlikely. The impact is therefore a bounded out-of-bounds read with limited confidentiality consequence and no write or control-flow primitive. The fix adds remaining-length guards before each access. |
